Linux version 2.4.18 (root@Cube) (gcc version 2.95.4 20011002 (Debian prerelease)) #1 Tue Feb 11 01:42:26 JST 2003 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000000dff0000 (usable) BIOS-e820: 000000000dff0000 - 000000000dff3000 (ACPI NVS) BIOS-e820: 000000000dff3000 - 000000000e000000 (ACPI data) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) On node 0 totalpages: 57328 zone(0): 4096 pages. zone(1): 53232 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=Linux ro root=302 Initializing CPU#0 Detected 599.723 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1196.03 BogoMIPS Memory: 223492k/229312k available (936k kernel code, 5436k reserved, 274k data, 192k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes) Inode-cache hash table entries: 16384 (order: 5, 131072 bytes) Mount-cache hash table entries: 4096 (order: 3, 32768 bytes) Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) CPU: Before vendor init, caps: 00803035 80803035 00000000, vendor = 5 CPU: L1 I Cache: 64K (32 bytes/line), D cache 64K (32 bytes/line) CPU: L2 Cache: 64K (32 bytes/line) CPU: After vendor init, caps: 00803135 80803035 00000000 00000000 CPU: After generic, caps: 00803135 80803035 00000000 00000000 CPU: Common caps: 00803135 80803035 00000000 00000000 CPU: Centaur VIA Samuel 2 stepping 03 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfb260, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 0: assuming transparent PCI: Using IRQ router default [1106/3123] at 00:00.0 isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd Journalled Block Device driver loaded Detected PS/2 Mouse Port. pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A block: 128 slots per queue, batch=32 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller on PCI bus 00 dev 89 PCI: No IRQ known for interrupt pin A of device 00:11.1. Please try using pci=biosirq. VP_IDE: chipset revision 6 VP_IDE: not 100% native mode: will probe irqs later VP_IDE: Unknown VIA SouthBridge, contact Vojtech Pavlik keyboard: Timeout - AT keyboard not present?(ed) keyboard: Timeout - AT keyboard not present?(f4) hda: ST360015A, ATA DISK drive hdc: IDE DVD-ROM 16X, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide0: probed IRQ 14 failed, using default. ide1 at 0x170-0x177,0x376 on irq 15 ide1: probed IRQ 15 failed, using default. hda: 117231408 sectors (60022 MB) w/2048KiB Cache, CHS=7297/255/63 hdc: ATAPI 16X DVD-ROM drive, 512kB Cache Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 hda3 hda4 < hda5 hda6 > Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 via-rhine.c:v1.10-LK1.1.13 Nov-17-2001 Written by Donald Becker http://www.scyld.com/network/via-rhine.html eth0: VIA VT6102 Rhine-II at 0xec00, 00:40:63:c3:89:aa, IRQ 11. eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1. NET4: Linux TCP/IP 1.0 for NET4.0 TCP: Hash tables configured (established 16384 bind 16384) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 192k freed Adding Swap: 498004k swap-space (priority -1) EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,2), internal journal Real Time Clock Driver v1.10e apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16) kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,5), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3-fs warning: maximal mount count reached, running e2fsck is recommended EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,6), internal journal EXT3-fs: mounted filesystem with ordered data mode. eth0: Setting full-duplex based on MII #1 link partner capability of 45e1. ip_tables: (C) 2000-2002 Netfilter core team ip_conntrack (1791 buckets, 14328 max) mice: PS/2 mouse device common for all mice usb.c: registered new driver hub usb.c: registered new driver hid hid-core.c: v1.8 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers usb-uhci.c: $Revision: 1.275 $ time 01:51:56 Feb 11 2003 usb-uhci.c: High bandwidth mode enabled usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 11 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: USB UHCI at I/O 0xd800, IRQ 12 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: USB UHCI at I/O 0xdc00, IRQ 10 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 3 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: v1.275:USB Universal Host Controller Interface driver